1807.1.2.1 Flood hazard areas. For buildings and structures in flood hazard areas as established in Section 1612.3, the finished ground level of an under-floor space such as a crawl space shall be equal to or higher than the outside finished ground level.

1506.3 Material specifications and physical characteristics. Roof-covering materials shall conform to the applicable standards listed in this chapter. In the absence of applicable standards or where materials are of questionable suitability, testing by an approved agency shall be required by the building official to determine the character, quality and limitations of application of the materials.

Section 1503.3 Coping. Parapet walls shall be properly coped with noncombustible, weatherproof materials of a width no less than the thickness of the parapet wall.

This code implies that single ply low-slope roof systems only qualify for ballasted applications if they meet the wind requirements set forth in Section 1504.8.

RoofingCode: Section 1505 Fire Classification 1505.1 General. Roof assemblies shall be divided into the classes defined below. Class A, B and C roof assemblies and roof coverings required to be

RoofingCode: Section 1505 Roof Assemblies Section 1505.2 Wind Resistance of Low-Slope Roof Systems. The low-slope roof systems described in Section 1507.5 which are mechanically attached, adhered to the roof deck

Roofing Code: Section 1504Roof AssembliesSection 1504.7 Impact Resistance. Roof coverings installed on low-slope roofs (roof slope <2:12) in accordance with Section 1507 shall resist impact damage based on the results

Roofing Code: Section 1507Requirements for Roof Coverings: Liquid-Applied Coatings1507.15 Liquid-applied coatings. The installation of liquid-applied coatings shall comply with the provisions of this section.1507.15.1 Slope. Liquid-applied roofs shall have a

Dampproofing and Waterproofing 1807.2.2.1, Surface Preparation of Walls Prior to the application of dampproofing materials on concrete walls, holes and recesses resulting from the removal of form ties shall be

Roof Assemblies Section 1505.2, Wind Resistance of Low-Slope Roof Systems The low-slope roof systems described in Section 1507.5 which are mechanically attached, adhered to the roof deck or ballasted shall